Troubleshooting Wedges on a
|
||
Description |
Probable Cause |
How to Correct |
| When sizing the material, the saw cuts one end wider than the other. |
The stock guide rail is out of adjustment. | Leading end is wider than the trailing end. Adjust the left end of the guide rail away from the machine. |
| Leading end is narrower than the trailing end. Adjust the right end of the guide rail away from the machine. |
||
| Material is being pushed sideways. | Check for slivers in the machine. Clean the machine. | |
| Check the feed rolls for not turning. Repair or replace. | ||
| Check the infeed conveyor or roller stand (if used) for square to the feed chains. Normally only affects long material. |
||
| Stock guide is not locked to the guide rail as material is fed into the machine. |
||
| Operator is not holding stock against the stock guide when feeding it into the machine. |
||
Questions?
We can easily be reached by phone or fax:
Telephone: 260.563.2102
Main Fax: 260.563.0206
If you prefer to send us an email, please check our contact page to easily get in touch with whoever you need!